Atomic Systems

Have made 2 attempts to complete this activity all runs fine till I arrive at Clapham Junction on the way back to Waterloo, then disaster strikes, the 442 AI service that leaves Clapham Junction heading towards Waterloo derails activty over, at the time of writing this I noticed the download count is 197 so not sure why im getting this problem and no one else.

Terry

Hi Terry,

I wrote this activity.

I tested the activity numerous times, with no problem. First of all we need to establish for sure if its only you getting the error. Also, how does it derail? Points, another train?

Cheers

Ali

Hi Ali thanx for the reply, I have sent you a email with screenshots of the collision as its not allowed to post collision shots in the forums,I have also sent you a pm.

Terry.

Hi Terry,

I cant quite see from those pictures, is it a head on collision on both lines?

If so than I have make a mistake with paths.

If not, I think a bounding box problem.

Can you confirm this please.

Cheers

Ali

Hi Ali.

Just to confirm its a head on collision both trains are using the same line.

Terry

When I try unpacking it it says Failed to Open?

Oh..wait.. It works, my mistake.

It couldnt be that you are playing it on V3 and it is built for V4. There may be a few extra lines

Run it in Activity editor and see if it still doesn't work

Just investigated this, paths do clash, and i have updated the file, but it has to be re-approved, so you'll have to wait guys.

Sorry for the inconvienience, I realised I added 1 more bit of AI at the end of testing, i forgot to test again, and it made the colliosion.

Cheers

A

Dont the signals work

Ali. If you are changing the activity (which I've just installed) I notice that the SWT 421 in the static consists is thrown up by route riter as missing. I also notice that it does not have the usual UK_ etc prefix that Dave uses for his CD stock. This would make me thing that it isn't actually on the Dorset CD. It's not mentioned in the read-me stock list so, if this is the case then what ukts file would be needed?

Best regards

Michael

codrivermike wrote:Ali. If you are changing the activity (which I've just installed) I notice that the SWT 421 in the static consists is thrown up by route riter as missing. I also notice that it does not have the usual UK_ etc prefix that Dave uses for his CD stock. This would make me thing that it isn't actually on the Dorset CD. It's not mentioned in the read-me stock list so, if this is the case then what ukts file would be needed?

Best regards

Michael

Yep, that was another problem I spotted and couldn't find it anywhere

philbozz wrote:

codrivermike wrote:Ali. If you are changing the activity (which I've just installed) I notice that the SWT 421 in the static consists is thrown up by route riter as missing. I also notice that it does not have the usual UK_ etc prefix that Dave uses for his CD stock. This would make me thing that it isn't actually on the Dorset CD. It's not mentioned in the read-me stock list so, if this is the case then what ukts file would be needed?

Best regards

Michael

Yep, that was another problem I spotted and couldn't find it anywhere

Oh Dear.

I'll just take that static out, i thought it was CD Stock.

Cheers

Ali

Hmmm...I can't even load the route now, TS keeps crashing out at 'Setting up simulation' :-/