NWE 2.1

ArthurC · Post by **ArthurC** » Mon Jan 01, 2007 5:46 am

Hell Folks

Happy New Year and may it be good for you all.

I recently purchased the new CD for this route and I have noticed there is a Patch available for download. I have tried to download this but it will not download as a ZIP file and when I look at the folder it just says Patch File.
Has any body else had this problem or do I even need the Patch.

Also can anybody advise me which file I need to make a change in so as overhead wires show. I did have this some months ago but my memory has let me down. {Must be getting old} LOL Any advice /help greatly appreciated.

All the best, Regards
Arthur

jetgriff · Post by **jetgriff** » Mon Jan 01, 2007 8:51 am

the patch should come as a zip file: UKTS_15561_NWE_V2.1_Patch_1 unzip this and it gives NWE_V2_patch#1 doble click on it should install.

Overhead wires should show unless turned off, when opening TrainSim go to 'options' .. 'advanced' and click them on

ArthurC · Post by **ArthurC** » Mon Jan 01, 2007 11:21 am

Hello Folks

I have just tried downloading the Patch file ID 15561 for about the fourth time and it does not download with a ZIP extension but as NWE V2.1 Patch.
I have overhead wires selected in options but I want to set the height

All help Appreciated Many thanks Regards Arthur

PeterC · Post by **PeterC** » Mon Jan 01, 2007 11:57 am

Hi Arthur
I've just downloaded this and you're right. However unzip it to a temp folder and you get the patch.exe to use.

Peter

ArthurC · Post by **ArthurC** » Tue Jan 02, 2007 3:33 am

Hi

Still no joy with the Patch file, I still cannot get it to be a Zip file to open.
I have reset the the wire height, reading another thread gave me the clue. You can set this height in the route TRK file.
Best Regards Arthur

ArthurC · Post by **ArthurC** » Tue Jan 02, 2007 9:03 am

Hello Folks

Managed it at last with the Patch file. I disabled my download manager and lo and behold it downloaded with the zip extension and is now installed. Best Regards Arthur