Page 1 of 1
Raildriver Problems?
Posted: Mon Dec 04, 2006 8:14 pm
by nath9425
After buying it at the Warely Show I have a few problems with RAILDRIVER.
1. In any Electric Logo it will flick continiously from 100% throttle to 100% break and it wont stop??? any suggestions
2. Half of the Deisel Units work partly, the train break is activated but nothing happens, i push up and down and it wont work!!!
Help!!!
Posted: Mon Dec 04, 2006 8:22 pm
by trainlover123
Ok, if you get Route-Riter, there is a utility embedded within it that configures .eng files to use it, as I found at Leamington this year, it's a bit jumpy if not properly done. (Sorry Martin!) That should fix your problems
Posted: Mon Dec 04, 2006 9:06 pm
by nath9425
I have downlaoded route-riter. The problems still occur though, so when I enter route riter where do I go from there???
Posted: Mon Dec 04, 2006 9:47 pm
by nath9425
Where abouts is this file? hud_dsl2.dat I cant find it anywhere!!!
Ahhh This is a nitemare!!!!
Posted: Mon Dec 04, 2006 10:05 pm
by PeterC
Open Route-riter. Select the Raildriver tab. In the left screen select the trainset folder of your loco. In the centre screen highlight the eng file. click show type of .eng. Then click modify for Raildriver the corect tab, i.e.electric.
Full details are contained in help, contents, Raildriver options.
Any problems PM me
Peter Cunningham
For Voyager click the combothrottle option when converting with Route-riter. Use the Series 2000 Raildriver Manager engine file and the combobrake Cabmaker file when operating the Voyager