wessex class 150/2

General MSTS related discussion that doesn't really fit into any of the other specific forums.

Moderator: Moderators

Locked
poodles
Been on the forums for a while
Posts: 108
Joined: Mon Oct 27, 2003 12:28 pm
Location: Birmingham

wessex class 150/2

Post by poodles »

hi, why is this train so slow? lol, i've tried adjusting the power, max force and max continuous force figure settings up in the thousands in the .eng file but still seem to be crawling out of stations at little more than 1mph on full beans.

the friction setting seems to be quite high, 678N/m/s, does this need to be adjusted to get it moving? in real life i'd probably say the 150s are no slower than a 158/159 at pulling out of stations due to being lighter etc, was hoping to try and get the same effect in msts! :)

Thanks
Top
jennings
Well Established Forum Member
Posts: 694
Joined: Thu Sep 22, 2005 11:45 am
Location: Birmingham

Post by jennings »

The solution is to remove any references in the .eng files that relate to gearing as this is what causes the rather slow accelleration your experiencing.

As i don't have a .eng file for a 150 to hand at the moment i'm not sure which parts need changing.
Top
swt455
Well Established Forum Member
Posts: 503
Joined: Mon Jul 11, 2005 8:24 pm

Post by swt455 »

i have never really had a problem with trains being too slow,


i tend to have problems with trains going to fast like the 321s and 313s
Top
Locked

Return to “[MSTS1] General MSTS Discussion”