disappearing locos

davvydo · Post by **davvydo** » Fri Dec 10, 2004 5:35 pm

why is it that whenever i run a loco on the Tallylyn route when i leave the wharf and head for pendre the loco is cust in half or just completely disappears.

is it because of the trees or is it just my machine???

saddletank · Post by **saddletank** » Sat Dec 11, 2004 12:30 pm

Have you got your display detail settings turned down? Some models display incorrectly when you ask the sim to run them at a lower detail setting.

davvydo · Post by **davvydo** » Sat Dec 11, 2004 12:37 pm

that doesn't work sorry i thinks its just the sim itself it can run without the 6 default routes that means no juddering with the picture

spontin · Post by **spontin** » Sat Dec 11, 2004 5:10 pm

davvydo wrote:why is it that whenever i run a loco on the Tallylyn route when i leave the wharf and head for pendre the loco is cust in half or just completely disappears.

is it because of the trees or is it just my machine???

I think it's a PC or graphics card related problem because there are no other reports of such problems.
What view are you using when you see this problem?
If you're too close to the loco in some views then you literally get inside of it !!

Steve

Atomic Systems

disappearing locos

disappearing locos

Re: disappearing locos