Page 1 of 1
help with ece part 1 patch
Posted: Tue May 26, 2009 11:04 am
by graeme01
hope some one can help. been away from sim for abit and discovered that there was and update patch for ece pt1, so i down loaded and installed fine only problem is when i come to use a scenario on ece pt 2 it wont load and says it is running a parralel file ??????. so do i uninstall pt 1 with no update or is there another way to get pt2 to run.
yours stumped
graeme
Re: help with ece part 1 patch
Posted: Tue May 26, 2009 12:07 pm
by ashgray
Now that you've updated part one, try re-installing part two. I seem to recall reading that this works (and I can see why...)
Ash
Re: help with ece part 1 patch
Posted: Tue May 26, 2009 12:24 pm
by gswindale
What patch for Part 1?
Europeanbahn wrote:
Patch loading sequence for East Coast Express Series
There are a number of patches for ECE series and they need to be loaded in this order so that everything works this is only applicable if you have all 4 parts
ECE1
ECE2
Leeds Loop
ECE2 patch
Herts loop
Taken from the
Europeanbahn Forum
Re: help with ece part 1 patch
Posted: Sat May 30, 2009 9:38 am
by graeme01
it's the patch for part 1 lkx-pbr. i have uninstalled pt2 and re-installed now i don't have the 3 extra services to york(the hull exec,etc) should i try and install again)