Atomic Systems

I have recently downloaded Train Store and while I think it is a terrific system and solved alot of problems I have noticed that since downloading I have lost all the ENG.files to the loco's in my trainset folder. I have a few routes downloaded and have quite a few loco's in the folder, some were downloaded from this fine site and some along with the route on C.D. Now im finding that loco's that I had fine tweaked ( sound, whistles,etc ) have reverted to a default sound. The sound of a stanier type whistle on a fowler 3F would make old Henry turn in his grave. Anyway my question is how can I restore the ENG files to my loco's

Hi there,
There are two options. Trainstore will store you locos to your chosen location (you set it up on start up) The easiest way to get your eng files back is in trainstore click tools then unstore evreything. It will put your eng files back in your trainset folders. Alternatively you can locate your trainset folder under the trainstore folder where it stores your locos and copy your chosen locos and place it in you msts trainset folder. Sorted
Sam

Thanks alot Sam, I will try your suggestions, I had a feeling there must be a solution out there somewhere

Hi, You Do not lose the .eng and.wag files when you start up trainstore It takes them out and stores them. That's why it loads so quickly. If you look in Start/My Computer/Local Disc C you will see a Folder named Trainstore and that's where they are . When you unstore Trainstore and look at the folder again you will only see the TSDATA folder.

Regards

Ron P