Atomic Systems

Thanks, guys.

I've been wondering about cabs, as well. I'm presuming (hoping) you can alias cabs and sounds. It's going to be a bit tricky if not. The extra locos released for download didn't have cabs, so I presume aliasing could be used.

I suppose we have to wait for the dev tools.

Out of interest, does anybody have any photos of the 3F cab interiors?

Cheers,
Kevin

Very nice progress. Will be interested to hear how you tackle the textures for RSD. The built-in content does have (IMO) realistic enough textures which no doubt contain many layers.

Blackpatch wrote:Very nice progress. Will be interested to hear how you tackle the textures for RSD. The built-in content does have (IMO) realistic enough textures which no doubt contain many layers.

Kev will cheat as usual and make it dirty

kevmt wrote: Out of interest, does anybody have any photos of the 3F cab interiors?

Hey Kevin,

I can acquire some for you if you would like?

trainmad wrote:

kevmt wrote: Out of interest, does anybody have any photos of the 3F cab interiors?

Hey Kevin,

I can acquire some for you if you would like?

Thanks Paul, that would be very helpful.

Cheers,
Kevin

Blackpatch wrote:Very nice progress. Will be interested to hear how you tackle the textures for RSD. The built-in content does have (IMO) realistic enough textures which no doubt contain many layers.

We'll have to see. Certain techniques may prove difficult due to lack of expensive software. Only time will tell.

(or I might cheat!)

Cheers,
Kevin

Very Nice and that's quite good work for a few days.

Will look forward to it

Cheers

Managed to do some more detailing :-



A picture of the 3F,in works grey, at Radstock.

Cheers,
Kevin

kevmt wrote:Cheers

Managed to do some more detailing :-

[Image]

A picture of the 3F,in works grey, at Radstock.

Cheers,
Kevin

haha!

Nice one!

Cheers,
Mike

Wow ! You've really brought that on, well done and keep up the good work, it's much appreciated .

That's just what needed for RS, a small shunter and a Jinty really fits that bill.

Brilliant work Kev

Yay! It goes...sort of

Great stuff Kevin!

Nice Kev .

Very Best Wishes,
Bob.

Looks nice !!! - how did you get it into KRS without the development tools ??

Cheers
Paul

Looking good...
One minor issue,the chimney could do with being slightly larger diameter