Atomic Systems

Had to withdraw this as it has delveloped a fault, line 113 'Instruction at 0x00000000 referenced memory at 0x00000000 Memory could not be read".

Anyway its only on this version that I uploaded, lucky I backed up a copy and this one works ok, just have a few corrections to signalling and will test and upload it, give me 24 hours.. sorry about this

That's weird Jet, when does this happen? i ran the second scenario on V7 ok so far, apart from some invisible signal poles and floating track and stuff it ran smoooooth!

Mart

Sure is weird, I've only had time to run a bit of the scenario Paddington-PlymouthHST as far as Newton Abbot but had no problems!
I think its fantastic that you have achieved what you have in such a short time.
Thanks John, looking forward to the 'fully scenic version'!

Justgeoff

It freezes up between Aller Jnc and Stoneycombe Sidings and you get that message on the 'down line'
It was reported and I tried my copy and sure enough..

Lucky I had a back up copy without the problem, I am just uploading it now.

Also I corrected the 'parked freight train in the fitted freight scenario that was causing the A1 collision.

Yes some poles float as well as the track in places, just needs the terrain checking to see if its retaining walls or embankment..

It will take a couple of weeks so i decieded to upload as is and give myself time to finish the scenery and do a final 'nitpicking' run both ways.

no problem with the roye apart from whats been mentioned at least you lay track faster than railtrack

p.s.jetgriff i live in plymouth so if you need help with pics tho they would be the way the line and stations are now

Hi, only had a small try last night on v7. On Dawlish shunt the loco & trucks were off the tracks -so the track layout was possibly changed after these items were added - it wasn't a problem - just moved them back onto the tracks with scenario editor & it was fine.

Mark

just spotted the wayward trucks in Dawlish yard, have corrected them in the V8 awaiting approval now.

Thanks,
looking forward to that, as spending next week at the Warren. So will not be able to play - sorry test it properly till the week after.

Mark

smarty2 wrote:That's weird Jet, when does this happen? i ran the second scenario on V7 ok so far, apart from some invisible signal poles and floating track and stuff it ran smoooooth!

Mart

Set your Scenery Detail to 10.

John

jetgriff wrote:just spotted the wayward trucks in Dawlish yard, have corrected them in the V8 awaiting approval now.

Hi,

Good to know you have an improved version in the pipe line. This route is very well put together. Looking forward to V8.

Regards
Mike

All seems ok, I uploaded V8 to UKTrainSim then just downloaded it to my memory stick and installed it on my 'test' computer.. plays good now.. you should get it available soon.

My detail was set at 10, all my settings are max. V7 would not get past that one spot, dont know why..

Jet, just downloaded SDB v8 and I'm afraid the sim CTD'd on leaving Newton Abbot, heading towards Exeter.

I also noticed that the Bristol portal, just a couple of miles north (east) of Newton Abbot was still in place from v5 even though there is track laid beyond it.

Any ideas on this CTD'ing would be appreciated.

Uninstalled v7 and re-installed v8 plus reinstalled the station signs.

That seems to have cured the Ctd's and line 113 errors I was getting in all departures from Plymouth.

Will have another go at the Cornish Riveria but may take awhile as a long way to Newton Abbot where in Ctd'd last time.

What a wonderful route. Thanks a million.

PS. Geoff - will you ever go back to the Chichester - Portsmouth (and perhaps up to Southampton?)

photons66 wrote:Jet, just downloaded SDB v8 and I'm afraid the sim CTD'd on leaving Newton Abbot, heading towards Exeter.

I also noticed that the Bristol portal, just a couple of miles north (east) of Newton Abbot was still in place from v5 even though there is track laid beyond it.

Any ideas on this CTD'ing would be appreciated.

Anyone?

johny wrote:

smarty2 wrote:That's weird Jet, when does this happen? i ran the second scenario on V7 ok so far, apart from some invisible signal poles and floating track and stuff it ran smoooooth!

Mart

Set your Scenery Detail to 10.

John

Cheeers mate, have done and will see what, BTW it was only a few of the poles and not all?

Mart