Page 1 of 1
dam ash tree will not delete
Posted: Sat Jan 19, 2008 10:37 pm
by jetgriff
just done a lot of work ... but not saved for 10 mins, now I have a Tree ash mid 01 stuck in the track and this will not delete, any way round this
Re: dam ash tree will not delete
Posted: Sun Jan 20, 2008 12:53 am
by tads1970
Hi,go into your editor,zoom to the tree,go under the earth and look up,you might have to zoom in a fraction more so you dont highlight the track-i get this when using linear bridge's seated just below the track.It's tricky but do-able.
Daz
Re: dam ash tree will not delete
Posted: Sun Jan 20, 2008 3:45 am
by jetgriff
no, no way can I get it to 'highlight', it seems to be just a 1d image, its only about 1 mil across underneath..
Re: dam ash tree will not delete
Posted: Sun Jan 20, 2008 10:05 am
by RSderek
click on the floor and draw am area circle around it, I have a feeling this tree does not have a bounding box.
If memory serves me right this is a forward facing poly.
if this is the case I should be able to fix very easy and get back to you, let me look.
regards
Derek
Re: dam ash tree will not delete
Posted: Tue Jan 22, 2008 7:43 pm
by iceman2117
hi, ...
..look who is the Axis- Euler in Original Mesh (Modeller). Then click in RS Editor who is the Mesh Axis Euler(Modeller Pose)
Press Del.
greets ice