Question about cab wiews
Posted: Mon Feb 11, 2008 9:17 pm
Can I change the cabview of my exported train and place it at the back of the train as opposed to the front?
Page 1 of 1
Re: Question about cab wiews
Posted: Tue Feb 12, 2008 1:55 pm
Anyone?
Re: Question about cab wiews
Posted: Tue Feb 12, 2008 7:33 pm
The cab view (in MSTS) will go wherever you define it in the loco's .eng file
CabView ( dhrb1.cvf )
HeadOut ( 1.35 2.47 -3.35)
In this case the cab is set 3.35m back from the centre of the engine.
CabView ( dhrb1.cvf )
HeadOut ( 1.35 2.47 -3.35)
In this case the cab is set 3.35m back from the centre of the engine.
Re: Question about cab wiews
Posted: Tue Feb 12, 2008 9:20 pm
OK thanks. How do I turn the cab view through 180 degrees please?
Re: Question about cab wiews
Posted: Tue Feb 12, 2008 9:32 pm
Anyone? Sorry I've nearly finished the module and I'm eager to get it uploaded. Patience is found never in a man by the way 
Re: Question about cab wiews
Posted: Fri Feb 15, 2008 4:22 am
Your view from a cabview is determined in your .cvf file. Open it with a Unicode editor and look for the views - they're three number groups with the middle one being the y axis. Change those to a number 180 deg. from where they are and you should have it.